DDPAI N5 Dual Radar Module OBD Hardwire Kit

Description

Upgrade your vehicle’s security with the DDPAI N5 Dual Radar Module OBD Hardwire Kit, designed to deliver AI-powered precision monitoring and battery-efficient motion detection. The millimeter-wave radar sensor scans the surroundings, automatically recording video 10 seconds before and after an event for complete incident documentation.

Unlike standard motion sensors, this AI-powered system recognizes repeat visitors, capturing events like scratches, theft, and unexpected movement beyond just collisions. With IPS Power Management Technology, it intelligently manages battery usage, reducing voltage consumption and extending battery life.

This system achieves an 87% reduction in operation time, allowing up to 15 days of motion-triggered recording without draining the vehicle’s battery.

Key Features:

• AI Base Smart Parking Mode for 24/7 vehicle monitoring
• Millimeter-wave radar motion detection with pre-event recording
• AI motion detection algorithm recognizes repeated movement and threats
• Battery-friendly operation with minimal power consumption (5mW)
• IPS Power Management Technology prevents battery depletion
• Radar Module Installation via Type-C OBD power connection

Radar Module Installation (Optional Accessory)

Step 1: Plug the Type-C connector of the OBD power cable into the Type-C port of the radar module.

Step 2: Connect the other end of the OBD power cable to the OBD port of the vehicle.

Step 3: Plug the Type-C connector of the radar cable into the Type-C port of the Dash Cam.

Step 4: Attach the electrostatic sticker to the recommended area as shown in the figure below. Remove the protective film from the radar, attach the adhesive side to the windshield close to the Dash Cam (make sure the indicator of the radar module is facing the windshield).

【 Take Note 】

● The figure above is for reference only, please refer to the actual situation.

● Do NOT place the radar behind the rearview mirror. Because rearview mirror obstruction may affect radar performance.

● The default low-voltage protection value is 12V. When the car battery voltage is lower than the set value, the power-off protection will be activated to ensure that the car battery does not lose power during parking monitoring.

● The step-down line supplies power from 12V to 5V and has a built-in high-precision voltage detection chip to output a more stable voltage.

● The OBD power cable is ONLY compatible with DDPAI Dash Cam.

● The OBD power cable only obtains power from the OBD port and will not cause safety hazards to the car.

● Please use and store the OBD power cable within the specified temperature range (Working temperature: -20℃ to 70℃, storage temperature: -30℃ to 85℃).